Scissor lift operation specification

Scissor lift is a kind of aerial work tool which is more widely used. With a large operating platform, it can provide large load capacity. The following Zhong Xin Da Zhou gives you an introduction to the characteristics and operating specifications of scissor lifts.

What are the characteristics and performance specifications of scissor lifts? Scissor lift is a kind of special equipment for aerial work with a wide range of uses. Its scissor mechanical structure makes the scissor lift more stable after lifting, with a large working platform and higher carrying capacity, so the aerial work range is larger and suitable for multiple people to use. Work at the same time. Make aerial work more efficient and safe.

The feature is that the lifting mechanism is made of high-strength manganese steel vantage point tube. Equipped with a safety protection device to prevent overloading of the scissor lift. Equipped with a safety protection valve to prevent the rupture of the hydraulic line. Equipped with an emergency descending device in case of power failure. The product is suitable for mobile aerial work such as installation and maintenance of aerial equipment in various industries. According to different requirements can choose different power forms (such as: three-phase AC power, single-phase AC power, DC power and internal combustion power, etc.), plus the manual hydraulic device, can be in the power outage or no power places as usual lifting work, and can be added to the telescopic platform, in the platform length is not enough to extend to the required position, so as to improve efficiency. It is the ideal product for modern tall buildings and equipment, and is a must for safe and civilized production at high altitude.

Scissor lift operating specifications

1, must be configured after special training, examination and qualified, licensed professional operators.

2, the operator must be in accordance with the provisions of the maintenance of machinery and equipment, in the implementation of the inspection and maintenance before starting the lifting platform, before work should check the working range of the platform car, remove obstacles that prevent the platform car from turning and walking.

3, support is an important preparation for the operation of the scissor lift, should choose a level ground, such as soft or undulating foundation, shall be solid with sleepers before work.

4、The scissor lift should generally start the lower arm, then the middle arm, and finally the upper arm. In the process of rotary operation of the lifting platform, the lower arm shall be raised to a certain height before the rotation, the rotation should be slow, while paying attention to the distance between the shear arm and the platform to the equipment to meet the safety needs.

5, the operator on the working platform should wear a safety belt, when working in the electrically charged area, the body should be grounded according to the provisions, lifting platform ascent operations should be directed by the person in charge of the work, the person in charge should be in accordance with the standard signal and lifting platform operator to contact. The signal sent shall be clear and accurate.

6, platform operations before the work, the person in charge of the work should be to the operator, technical and safety instructions, the content should include: work content and requirements; safety precautions and danger points; personnel division of labor and the scope of responsibility. The person in charge of the work should check the condition of the car and the operator, but also be responsible for checking the terrain environment and whether the take-off and landing meet the requirements of the safety and technical measures or the work plan formulated in advance, and if there is any discrepancy, the corresponding measures should be formulated before starting the work.

Comments or leave us a message:

More Posts You May Find Interesting